How to operate the lithium battery forklift

1. When the lithium battery forklift is in operation, do not mistake the "forward, reverse" direction switch as a steering switch. Unless you need to decelerate urgently, don't step on the brake pedal directly.

2. When the vehicle needs to decelerate, relax the acceleration pedal and lightly depress the brake pedal, so that the deceleration energy can be fully used. If the vehicle has a regenerative braking function, the kinetic energy during deceleration can be recovered.

3. In the operation of lithium battery forklift vehicles, special attention should be paid to the timely charging of the battery and the correct protection of the battery. Pay attention to the method when charging the battery, not only make the battery enough electricity, but also can not form the battery overcharge.

4. During the operation of the vehicle, if the battery power is found to be insufficient, the battery should be charged as soon as possible to prevent the battery from over-discharging.

5. In the operation of lithium battery forklift vehicles, try to minimize the use of long-term and long-distance acceleration. When the vehicle starts and the speed increases, stabilize the acceleration pedal. If the road condition is better, the vehicle will continue to accelerate.

6. When the electric forklift is going down a slope, do not disconnect the circuit that drives the motor, and quietly step on the brake pedal to make the vehicle run in a regenerative braking condition, and use the kinetic energy of the vehicle down to reduce the energy consumption of the battery.　

Extended materials Regarding the operating procedures of the forklift 1. Check whether the gear has been reset and whether the ignition device has been activated. 2. Put down the hand brake (if the ground is uneven, step on the brake before stepping on it.) 3. If it continues, press the clutch (the left pedal is the clutch, the middle brake is the brake, and the right throttle is the accelerator). The second gear of the rear wheel means The driving vehicle is in reverse gear. 4. Move the fork up and down to the joystick on the upper left, and move it up